TRAILER COUPLER
ITEM# DESCRIPTION
1
2" Trailer coupler
2
Locking handle
3
Channel lock
4
Adjustment nut
5
2" Trailer ball (not included)
To adjust coupler to ball:
Set the coupler and tongue on to the 2" trailer ball on your vehicle.
Raise the locking lever, push up on channel lock and turn the nut to tighten or loosen the
coupler. Proper adjustment is obtained when the coupler is as tight as possible on the ball and
the locking lever can still be opened and closed.
Before towing your trailer be sure to check the capacity of your trailer hitch on your
vehicle
(never exceed this or your trailers capacity).
The Marlon trailer is equipped with a 2"
coupler and must be used with a 2" trailer ball. Make sure that the trailer ball is completely
engaged in the coupler ball.
WHEEL & HUB ASSEMBLY
NOTE:
Bearings should be repacked every 2,000 miles (3,200 kilometers). Your trailer dealer
or any automotive shop is equipped and able to repack the bearings if you’re unable to do
yourself.
For your convenience, a grease zerk fitting is located behind
each wheel which
only requires the use of a grease gun to service, or you can do it manually as follows;
Repacking Wheel Bearings
1. Loosen wheel bolts (Do not remove!).
2. Support trailer so wheels are off the ground safely and secured.
3. Remove bolts and wheel.
4. Disassemble hub.
5. Clean hub and pack bearings with wheel bearing grease.
6. Reinstall bearings, nut, and cotter pin.
Caution:
DO NOT over tighten nut. The hub must turn freely and without play.
7. Re-attach bolts and wheel (Torque to 80 lbs.).
OWNER’S MANUAL /
