MR 150M–1050M SINGLE – MXIII CONTROLLER
OPERATION
29
4. System Type
This program step is used to set up the number of valves (1, 2, 3, or 4) in the system.
1. Use Up or Down buttons to adjust this value.
2. Press the Extra Cycle button.
5. Regeneration Type
This program step is used to set up the trigger type.
1. Use Up or Down buttons to adjust this value.
2. Press the Extra Cycle button.
6. Valve Type
This program step selects the valve type (2750, 2850, 2900s, 3150, 3900, Stager-Butterfly, or Stager-Notch Cam)
1. Use Up or Down buttons to adjust this value.
2. Press the Extra Cycle button.
7. Regenerant Flow
This program step selects the regenerant flow type (Downflow, Upflow, or Upflow Fill First)
1. Use Up or Down buttons to adjust this value.
2. Press the Extra Cycle button.
MASTER PROGRAMMING GUIDE
8. Remote Signal Start
This program step selects the remote signal start. Hours, minutes, and seconds can be changed. When Remote
Signal Start is active, the main screen will display. The options are either Off or set to the desired time.
1. Use Up or Down buttons to adjust this value.
2. Press the Extra Cycle button.
Example: Remote Signal Start set to 6 minutes.
If the Signal is detected continuosly for 6 minutes, the display will count down to 0
and it will remotely start.
