marko MHT-QWM, Instruction Manual, Page: 6 / 8

6
B: Mark your wall with the hole positions to match the mounting plate,
as shown in the diagram below.
C: Using an 8mm drill, create the 4 mounting holes as marked in the
previous step. The holes should be approximately 3.5cm deep.
D: Put the 4 plastic expansion plugs (included) into the mounting holes
one by one
– they should be flush against the wall surface.
E: Fasten the 4 screws (included) into the expansion plugs, until the
screw head is 4-5mm away from the wall surface.
F: You can now mount the product onto the wall. Once all four screws
are lined up, the mounting plate should shift slightly to the left then
down, held securely. Do not attempt to operate the heater until all four
screws are holding the product securely to the wall.
G: For safe use of the product, ensure that the heater is fitted correctly,
never installed upside down or ceiling mounted.