Betrieb • Operation • Fonctionnement • Exploitatie
10
Setting Locomotive
Parameters with the
Control Unit
1. Requirement: Setup as
in diagram 1. Only the lo-
comotive to be changed
can be on the track.
2. Press the “Stop” and
“Go” at the same time
until “99” blinks in the
display.
3. Press the “Stop” button.
4. Enter the address „80“.
5. Hold the speed control
knob in the reverse direc-
tion position constantly.
Press the “Go”
button while
you do this. The
headlight on the
locomotive will
blink. If no, repeat
starting at Step 2.
6. Enter the register number
for the parameter to be
changed (=> List 1).
7. Activate the direction
reversal.
8. Enter new value
(=> List 1).
9. Activate the direction
reversal.
10. End the procedure by
pressing the “Stop”
button. Now press the
“Go” button.
Diagram 1
1
1
99
1
2
80
1
80
1
2
1
01
01
1
1
2
10
10
1
List 1: parameter
Register Number
Value
01
01 - 79
Address
03
01 - 63
Acceleration delay
04
01 - 63
Braking delay
05
01 - 63
Maximum speed
08
08
Reset to series values
63
01 - 63
Volume
