2
3.Installing / hanging up the awning
3.1 Remove the protective covering and check all parts
are present.
3.2 Mark holder site where it is to be attached with drill
holes and then drill. Both holders are to be installed
with a 20 cm gap to the outer edges of the cassette
awning.
Additional brackets may be used.
3.3 Fasten the holders vertically above one another.
They must be mutually aligned. (plumb line).
3.4 Hang the cassette in the holders, position it and
tighten the SW10 securing screws.
3.5 Mark the position of the tension sectioning fastening
means depending on awning extension length and
fasten them in place.
Retaining post with base plate is to be screwed in
horizontally sited on a strong base.
Retaining post with ground sleeve: anchor the sleeve
plumb vertically in concrete, push the sectioning into the
sleeve and then slide the retaining post on. Clamp the
post in place with the hexagonal SW13 screw.
Wall holder: screw the wall plate approximately 985 mm
high on the wall and mount the wall holder using the
cylindrical SW4 screws.
3.6 The handle position can be adjusted with the
clamping screw on the tensioning arm.
3.7 Set its height so that the awning is tensioned dead
straight.
Caution. The clamping screws must be
retightened after adjusting the handle height.
3. Safety note
Caution. Awning under tension. Keep a good hold
of the handle when extending.
4. Important
Hand over the attached Operating Instructions to the
awning user and advise him or her comprehensively
on awning safety and use.
Cap
Retaining
post
Cap
Retaining post
Insertion sec-
tioning
Cover
Ground sleeve
M5x30 cylindrical
screws
Cap
Wall holder
Wall plate
Clamping screws
Grooved
arm
Handle