5. Troubleshooting
5.1
General
The information in this section is intended to assist the op-
erator, maintenance and the service personnel in locating the
source of problems which may occur with the cooker. Be-
fore following any of the procedures given in this section,
the operator/maintenance person should be thoroughly fa-
miliar with Section 4 (“Operation”) of this manual.
If the problem cannot be readily corrected without the use of
tools, the operator/maintenance person should contact the
nearest Market Forge service agency for assistance.
5-1
TROUBLE
POSSIBLE CAUSE
REMEDY
POWER light does not come on
when the POWER switch is
pressed into the on position.
1. No power to unit.
2. Fuse blown.
3. Faulty POWER switch.
1. Be sure the power supply is on.
2. Replace fuse.
3. Check/replace POWER switch
).
Steam continuously leaks
through the door gasket.
1. Misaligned door.
2. Faulty pressure switch.
1. Check to be sure cooking compart-
ment door is properly aligned. (See
Section 6.7.)
2. Replace the pressure switch
).
Steam generator will not fill.
1. Open drain valve.
1. Close drain valve.
Generator will not create
steam.
1. 208/240/480 power supply is not
connected or not turned on.
2. Cooking compartment door is ajar.
3. Cooking compartment door is ajar.
4. Faulty door magnet or magnetic reed
switch.
5. Lime buildup in the steam generator.
6. Faulty circuit breaker.
7. Faulty control panel TIMER.
1. Check to be sure 208/240/480 power
is connected and on.
2. Check to be sure that the cooking
compartment door is closed and
latched.
3. Check to be sure cooking compart-
ment door is properly aligned.
4. Check magnet (P/N
needed.
5. Clean the generator per Section 4.3.
6. Check circuit breaker at your 208/240/
480 volt service connection. Reset if
necessary.
7. Check/replace control panel Timer if
necessary (P/N 08-6563).
