MP Series (Active/Passive) - 4 -
User Manual / Manual de uso
1. LIMIT INDICATOR
: The Limit Indicator will blink on occasion when the built-in limiter is active.
NOTE: If the indicator glows or starts to blink frequently, you should turn down the level (3).
2. SIGNAL INDICATOR:
The Signal Indicator will glow when there is a signal received to the
input connectors (8)
3. Subwoofer Gain Control :
This knob is used to regulate the output level of the subwoofer.
Use this to set the balance between the speakers and subwoofers.
4. PROTECT INDICATOR :
The PROTECT INDICATOR will begin to glow when the subwoofer goes
into protect mode.Protect mode prevents the subwoofer amplifiers from over-temperature.When
the wsubwoofer goes into protect mode all output will stop. This is to protect the subwoofer and
any speakers connected to subwoofer.
5. POWER LED :
This LED will be lit when the power is ON.
6. High Pass XLR Output :
These outputs are used to send signal over 120 Hz to feed a mid/high
active speaker or power amp.
7. Phase Switch :
The PHASE SWITCH reverses the polarity of the subwoofer.This switch depends
on the placement of the subwoofer relative to the speaker.
8. Full Range XLR Input :
These connections are designed to accept a line signal from a mixer or
other line level device with a balanced output .
9. Thr u(Full Range Output) :
These output are used to send the signal from the FULL RANGE
INPUTS to another device.
MP 18AM
MP 18AM
PHASE INVERTION
Z
&
1
3
4
5
2
9
8
7
6