Mark Klimat 15-15, Technical Manual

Page: 4 / 96

4
1.2 Type indication
Type dimensions (mm)
Klimat 15-15 975x975
Klimat 15-20 975x1280
Klimat 20-20 1280x1280
Klimat 25-20 1530x1280
Klimat 30-20 1890x1280
Klimat 35-25 2195x1530
Klimat 35-35 2195x1530
Klimat 40-35 2508x2195
1.3 General warnings
Incorrect installation, adjustment, alteration, maintenance activity or repair may lead to material
or environmental damage and/or injuries. The appliance should therefore be installed, adapted or
converted by a skilled and qualified installer, taking into account national and international regula-
tions. Faulty installation, adjustment, alteration, maintenance activity or repair shall render the
warranty void.
1.4 Safety
The air treatment unit must be fitted with a lockable isolator switch (not supplied as standard).
Always disconnect the appliance from the mains when carrying out maintenance or repairs. The
motor and fan take some time to stop after the voltage has been switched off. Wait for at least
two minutes before opening the fan doors. Always comply with national and/or regional regula-
tions.
2.0 Positioning the appliance
On receipt, check immediately that the supply had been delivered in full. Check also for any dam-
age caused during transportation. If what is delivered does not comply with the goods indicated
on the packing list, and/or damage during transportation is recorded, the recipient must state this
on the delivery note indicating the date of receipt. If the recipient fails to comply with the require-
ments above, he shall have no right to claim.
2.1 Assembly [15] [16] [17]
To avoid contact noise, we recommend that the air handling unit be placed on a level, vibration-
free floor or roof structure. The roof structure must be sufficiently stable, and must have enough
load-bearing points to prevent the air handling unit from bending. The air handling unit must be at-
tached to the roof structure. The unit must be placed on a level surface to ensure that any con-
densation is properly drained off. Air handling units incorrectly installed can cause the inspection
doors in the unit to jam and possibly result in the unit leaking. With units with a condensation ex-
tractor, the height of the installation structure must be at least the same, or higher, than the re-
quired siphon height. Note: if the air treatment unit replaces the roof in the location where it is
installed, the manufacturer must be aware of this in advance so that appropriate measures may be
applied.
06_61_000 Klimat:Opmaak 1 21-07-2009 16:12 Pagina 4