7
cONtROl cHANGe
In Control Change (CC) mode the MULTIAMP MIDI PEDALBOARD switches send control change commands from CC #0 to CC #7 to turn ON/
OFF the effects on your Multiamp. The Control Change MAP at SYSTEM>MIDI menu on your Multiamp (firmware V 4.0) allows you to assign
a control change number to each single effect to turn ON/OFF the effect assigned to a specific Control Change.
The number above is the control change number to map with the selected effect on the bottom of the display, use the VALUE control to select
the effect to map to, choosing the assigned control change number with UP and DOWN buttons of the Multiamp, then press ENTER to save
the MAP.
To switch from Program Change to Control Change mode on the MULTIAMP MIDI PEDALBOARD hold switch #1 for few seconds , “CC” will
appear on the display, red light numbers show the CC ON and green light the CC OFF (ON/OFF also appear on the display when you push
the switches).
The MULTIAMP MIDI PEDALBOARD also allows to program the ON/OFF status of Control Change when it sends Program Change (to switch
presets).
To set the 8 CC related to a Program Change switch, select the desidered PC number pushing the related switch, then hold switch #1 for few
seconds to go in CC mode; select the ON/OFF setting of the 8 switches and then press “OK”, it will appear “STORED” on the display to show
the CC configuration is saved for that preset (repeat the operation for the other desidered presets).
