Mark Climate Infra Line G20, Technical Manual, Page: 27 / 60

27
Installation Instalacja
1.5
1.5.1
1.5.2.1
1.5.2.2
1.5.2.3
1.5.2.4
Installation
Upon delivery check if all the parts are present
and take note of any damage. Check that you have recei-
ved the right model.
General
When installing the radiant heaters the applicable
regulations (from the gas company or the building code)
should be observed. Take particular note of
the latest version of the gas installation regulations.
A radiant heater may only be installed in a suitable room
and at the suitable location!
Air intake and flue gas discharge course
This combined duct must have a minimum resistance, so
it should contain as few bends as possible.
The diameter is the same across the entire track.
The duct must not be supported on the heater, but must
be suspended effectively (See also 1.4.9).
The flue gas system C12 must be installed from the
unit with a minimum slope of 3º. Follow the bracket
instructions of 1.9
Black bulb sensor/Room thermostat
For an optimum adjustment the sensor/thermostat
should be placed in “view” of the heater, at a height
of approx. 1.5 metres from the floor.
Gas supply and connection
The heater should be attached to the 1” gas inlet
pipe. An approved gas stop cock must be attached
within easy reach of the burner section.