
User’s Guide
5
Mounting force gauges
To mount a force gauge, it is necessary to
temporarily remove the gauge adapter from the
crosshead. Loosen the two 5/16 screws (shown
at left) using the included tool kit. Then, mount
the gauge to the adapter using the four included
gauge mounting screws. After the gauge is
mounted to the adapter, mount the adapter back
onto the crosshead with the 5/16 screws.
Mounting grips and fixtures
The ESMH includes a loading plate to which a
grip or fixture may be mounted. This plate can
be mounted to the end of the stand with four
screws (shown at left). Before mounting the
loading plate, mount the grip or fixture to it,
using the matrix of tapped holes if required.
Setting up the controller
Plug the controller cable into the 9-pin male connector located beside the
motor. See illustration to left.
Connector for optional set point cable /
overload protection module
Connector for controller