4 MENU
4.1 Menu functions:
To access the menu you have to press the SET button. Every time the Up/Down
button is pressed the next/previous menu item is shown, press SET to enter the
menu.
x
Course alarm
St 1
x
Damping
St
2
x
Display layout
St 3
x
Key sound
St 4
x
Contrast
St
5
x
Calibration St
6
x
Align compass
St 7
x
Variation
St
8
x
Close menu
4.1.1 Off course alarm (ST1)
The Off Course Alarm can be set for a certain course to steer by and a separate
boundary on both sides of the course. The buzzer inside the unit will beep when the
cours is out of the boundary.
x
Press SET in the default view to enter the menu, press SET again to enter the
Course Alarm Menu (ST1).
Use the up/down buttons to set the preferred course.
x
Press SET and enter the Portside alarm boundary with the up/down buttons.
This can be set from 2 to 45 degrees difference.
x
Press SET and enter the Starboard alarm boundary with the up/down buttons.
This can be set from 2 to 45 degrees difference.
If the “Set course” is 246, the “Limit portside” set to 3 and the “Limit starboard” is set
to 2, then the alarm will sound if the course change is smaller than 246-3 = 243 and if
the course is higher than 246+2 = 248 degrees.
Use the down button in the default view to set the Alarm ON/OFF (see 3.4).
4.1.2 Damping (ST2)
Damping allows the user to change the damping level as conditions change. The
damping controls the averaging period over which the heading is displayed. Damping
does not make the compass less accurate, only slower. Damping levels can be set
from Off and 1 up to 7. In normal conditions level 2 is used.
x
Press SET in the default view to enter menu. Press the up/down buttons to
select the Damping menu (ST2), press SET to enter the Damping menu.
Use the up/down buttons to change the value.
x
Press SET short to enter the selected value or
x
Press the Light button to reset the value to default (2) or
x
Keep SET pressed for two seconds to exit to the default view.
Compass
Display CD110
4
