6
MIDI
Marion Systems
Transpose Controls
There are two push button switches labeled “A” and “B.” The two switches perform the following functions:
• In SPLIT mode if only the “A” LED is lit, the TRANSPOSE buttons only affect transposition on the lower
section of the keyboard. If only the “B” LED is lit, the TRANSPOSE buttons only affect transposition on
the upper section of the keyboard.
• In the POLYPHONIC modes, if only the “A” LED is lit, the TRANSPOSE buttons only affect transposition
of SEM A. If only the “B” LED is lit, the TRANSPOSE buttons only affect transposition of SEM B.
-2
-1
0
+1
A
B
+2
TRANSPOSE
VIBRATO LFO
FREQUENCY
AMOUNT
PRES
MOD
FINE TUNE
VCO 2 DETUNE
Turn this knob to
set the vibrato rate
Turn this knob to set
the maximum
vibrato amount
applied with the
Mod Wheel
or aftertouch
Turn this knob to
detune oscillator 2
on both SEMs
Mod Wheel
use it to
add vibrato/modulation
Pitchbend wheel
use it to
bend notes
Use these buttons
to transpose the
keyboard octave range
for each SEM
Use this knob to
fine tune all oscillators
+/- one semitone
(one half step)
Headphone jack
Headphone volume
The Bendbox
MIDI
The TVS-PRO communicates MIDI information on MIDI channels 1 thru 7. In order to enable MIDI OUT from its
keyboard, you must turn on RE-TRIGGER in the Keyboard Control section.
MIDI IN
The TVS-PRO recognizes the following MIDI commands:
• Note ON
• Note OFF
• Pitchbend (range can be set on the TVS-PRO)
• Transpose (from an external keyboard)
• Mod Wheel (modified by Bendbox AMOUNT pot)
• Aftertouch (modified by Bendbox AMOUNT pot)
