Precision Spotlight Instructions
Precision Spotlight Instructions
OPERATION
BULB REPLACEMENT CAUTION! AvOID TOUCHING THE GLASS SURFACE OF THE
NEW BULB. (TOOLS REQUIRED: MEDIUM PHILLIPS SCREWDRIVER)
1. Remove 2 screws on bottom of lens bezel
and remove bezel.
2. Remove 6 screws from around the lens.
3. Remove lens and reflector as an assembly.
SOS
(· · · — — — · · ·)
Pressing this button the light will begin to signal the
Morse code distress signal. Press again to turn off
Power on/off
Speed Control
Pressing this button will
allow you to change speed
of the light, SOS, and Sweep
Angle function
Auto Sweep
When this button is pressed
the light will begin to sweep left
and right at 90° for slow speed
and 70° for high speed. Press
the button again or a directional
button to stop the sweep
1. Remove the screw holding the
metal grounding bar behind
the reflector. Remove the bulb
assembly by pushing on the
bulb so it exits the back of the
reflector.
2. Unplug bulb and replace with
new bulb. (or 24 volt bulb if
installation requires)
CAUTION! AvOID TOUCHING THE GLASS SURFACE OF THE NEW BULB.
4
5
MAR_TL_029_1011_Precision_Spotlight_ Manual_6x9_Ins.indd 7-8
11/3/11 11:16 AM
