10
(NiMH) 2800 milliampere-hour (mAh) and above. Make sure to
observe correct battery polarity (positive and negative). Reverse
charging of the battery is not acceptable. DO NOT use non-
rechargeable batteries to run the vent. Be sure to clean the battery
contacts before installing a new battery. Use the flat surface of
a pencil eraser, or if heavier build-up has occurred, use either a
fine emery cloth or fine grit sandpaper (especially on the positive
battery contact). If needed, apply some silicone grease around the
perimeter of the solar array and reattach the array to the cover with
the three screws and sealing O-rings (do not over-tighten). Dispose
of the old battery properly.
NOTE: The vent can work without the battery, but only during
sunlight hours.
• Check the Solar Array & Fan Motor
If the motor still did not turn when the battery was removed, either
the array is damaged or the motor does not work. Contact Technical
Service for warranty concerns.
LIMITED WARRANTY
Please visit www.marinco.com/limited-warranty for warranty
information.
Please contact Actuant Electrical Group
E-mail: [email protected] to request a warranty claim
For more information about Marinco products and services, please
visit marinco.com
