EZ Mount Installation (Surface Mount Only)
1. Disconnect battery positive leads at the batteries for safety
2. Choose mounting location on a flat surface close to the batteries
3. Select pan head (or similar) screws for mounting - use either M5 or 10g imperial (not included)
4. With Actuator removed, use the switch base as a mounting template to mark the hole positions.
See details on next page for Actuator removal
5. Drill holes and screw switch base into position
6. Connect cables to studs ensuring that batteries and loads are correctly fitted
7. Ensure cables are secured to ISO/ABYC standards, and that cables are
supported so they are not placing unnecessary strain on the battery switch studs
8. Check that spring washers are fitted beneath nuts
9. Tighten the stud nuts to 13.5 Nm (10 lbf)
10. Slot the side panel(s) into the Actuator as required
11. Replace Actuator, ensuring that both switch base and Actuator are both in their “OFF” positions
12. Lock the Actuator Grey fastening screws
13. With switch in “OFF” position connect battery positive leads at battery
14. Check switch operation
Example System:
NOTE -This diagram is a guide only showing Dual Bank Control Switch
connections and is not intended as a full electrical systems wiring diagram.
Double Pole/DBC
EZ Mount
Dimensioned
Double Pole/DBC
EZ Mount Base
Dual Bank Control Switch
Loads
Engine
Battery
Battery
Start
+
-
+
-
House
DVSR
Loads
Positive
Bus
Negative
Bus
House
Battery
Fuse
Optional
Start
Batt
Fuse
Example System: NOTE -This diagram is a guide only
showing Dual Bank Control Switch connections and is
not intended as a full electrical systems wiring diagram.
+
1
2
+
1
2
Loads
Engine
Battery
1
Battery
2
Loads
+
+
OFF
ON
ON
PARALLEL
1
1
2
76.2 [3.00]
97.8 [3.85]
97.8 [3.85]
76.2 [3.00]
Ø5.5 [
Ø0.22]
97.8 [3.85]
15.6 [0.61]
76.9 [3.03]
92.5 [3.64]
62.4 [2.46]
30.1 [1.19]
27.5 [1.08]
DVSR (710-140A)
provides automatic
battery charging
of second bank
TO
RQ
UE
TORQUE
Panhead
Cheesehead
Sockethead
