MARIMEX 10992055, Instruction

Page: 39 / 52

39
EN
8. Insert the expansion nut into the drilled hole and secure the assembled shower to
the ground using the anchor bolts.
9. Install the two-piece base.
10. First remove the water inlet armatures from the kit, check the O-rings and gaskets
and screw the water inlet armatures clockwise onto the threaded fittings of the
water inlet and tighten.
Secure the back cover to
the shower base as shown
in the figure.
Align the latch bolt of the
front base cover as shown
in the figure.
Gently press down the
front base cover and
install it.
Water inlet
Adapter for
connecting the water
supply
11. Prepare a hose with a closed water supply and connect it to the adapter for
connecting the water supply.
12. Once the water supply has been connected to the shower body, open the water
supply provided that the pressure in your water supply network does not exceed 3,5
bar. After connecting the solar shower to the water supply, fill the shower body tube
fully with water and vent it at the same time - open the filling valve and at the same
time open the control lever armature to the hot water position and keep it open,
until a steady flow of water starts coming out of the shower rosette. Then push the
control lever to the “Closed” position. The solar shower is ready for use. To connect
the solar shower armature to a water supply network or a domestic water system,
use only standardized, approved and undamaged plumbing assembly elements.
Finally, check the tightness of the armature connections.
13. Before using the shower for the first time, press the button of the sensor light
switch. The button is then pushed down into the bottom side of the shower head
and the sensor light function is activated. If you need to deactivate the sensor light
function, press the button again and the button is released and reset.
The sensor light activates under the following conditions:
1. It is dark outside, e.g. at dusk or at night.
2. There is someone moving within the sensing area (the person cannot stand
still). The sensor light is infra-red, the sensing area is approximately 2 meters.
After the person leaves the sensing area, the sensor light automatically goes off
after approximately 40 seconds.
Flexible hose
Quick coupling
Sensor light switch