ENGLISH - 15
17. RECORDING OF CONTENTS PROTECTED BY
COPYRIGHT: Recording of copyright-protected material
for a use other than personal is against the law if done
without permission by the owner of said copyright.
18. INSTALLATION OF THE CATV SYSTEM: The
installer of the CATV system must follow the provisions
of article 820-40 of the NEC, ANSI/NFPA 70, which sets
forth the requirements for proper grounding installation
and particularly specifies that the earth terminal of the
grounding system must be connected to the grounding
system of the building as near to the entering point of
the cable as practically possible.
19. FCC INFORMATION (FEDERAL COMMUNICATIONS
COMMISSION) FOR THE USER: This equipment
generates and may radiate radiofrequency energy and if
not installed and used according to the instructions it
may cause interference to radio communications.
These limits are designed to provide reasonable
protection against interferences in a residential
installation. However, there is no guarantee that
interferences in any given installation will not be
produced.
If this equipment causes damaging interference to radio
or television reception that may be determined by
turning the equipment on and off, we recommend the
user to try and correct the interference through one or
more of the following actions:
•
Re-orient or relocate the receiving antenna
•
Increase the separation between the equipment and
the receiver
•
Connect the equipment and the receiver to outlets
in separate circuits
20. EXTERNAL ANTENNA INSTALLATION / SAFE
ANTENNA AND CABLE CONNECTION: If an external
antenna or cable system is connected to the equipment,
make sure the antenna or cable system is grounded to
provide protection against static charges and surges.
Article 810 of the National Electrical Code, ANSI/NFPA
70 (in Canada, part 1 of the Canadian Electrical Code)
provides information on the correct grounding of the
mast and support structure, the connection of the
grounding conductors to an antenna discharge unit, the
size of the grounding conductors, the location of the
antenna discharge unit, the connection to the grounding
electrode system and the requirements for the
grounding electrode system.
The external antenna system must be placed as far away
from electrical lines as possible and where it may never
come in contact with these power sources in case of fall.
When installing an external antenna, special attention
must be paid to avoid contact with electrical lines,
circuits or other sources of energy since this could
prove to be lethal.
Due to the danger involved, the antenna installation
must be performed by a professional.
