Revision 1.8.3
Page 123
Figure 117
– Configuring GPS Operating Mode on a GPS100
The allowable options for GPS Mode ar
e “1D” which allows the GPS to report data when only a one-
dimensional fix (time only) or better is obtained; “2D”, which allows the GPS to report data only when
a two-dimensiona
l fix or better is obtained; “3D”, which allows the GPS to report data only when a
three-
dimensional fix or better is obtained, or “Auto” (default), which allows the GPS to report any
available data, regardless of the quality of the fix.
6.14.4
Device Label
A label may be assigned to the GPS100 as an aid to identifying the device over the network.
Typically, this would describe the location of the GPS on the vessel.
See section 3.3.4 for details on how to enter a textual value.
6.14.5
SBAS (WAAS) Enable/Disable
The DSM570 is capable of enabling or disabling the SBAS (WAAS) function on a Maretron GPS
Antenna/Receiver (GPS100). You can change this setting by pressing the Enter key (
) with the
“SBAS: WAAS,EGNOS,MSAS:” menu item selected which causes the screen shown in Figure 118 to
be displayed.
