Revision 1.7.2
Page 83
Figure 67
– DSM150/DSM250/DSM410 Copy alarms settings from local display
After you select this menu item and press
Enter
, the alarm settings from this DSM410 unit will be
copied to the selected remote DSM150/DSM250/DSM410 unit.
6.9.3 Copy device selection from local display
Since it is normally desirable for all DSM150/DSM250/DSM410 units on a network to display the
same sensors, it is possible to copy the device selection settings from a DSM410 unit to a remotely
located DSM150/DSM250/DSM410. In this way, it is possible to make all device selection changes on
a single DSM150/DSM250/DSM410 unit and then quickly and conveniently duplicate these new
device selection settings on other DSM150/DSM250/DSM410 units attached to the network. Figure
68 below shows this menu item highlighted.
Figure 68
– DSM150/DSM250/DSM410 Copy device selection from local display
After you select this menu item and press
Enter
, the device selection settings from this DSM410 unit
will be copied to the selected remote DSM150/DSM250/DSM410 unit.
