Maretron DSM410, User Manual

Page: 56 / 289

DSM410
User’s Manual
Page 40 Revision 1.7.2

Bar Graph (see Section 7.2 on page 211)

Compass Rose (see Section 7.3 on page 211)

Date (see Section 7.4 on page 213)

Date/Time (see Section 7.5 on page 213)

Gauge (see Section 7.4 on page 213)

GPS Status (see Section 7.7 on page 215)

Half Gauge (see Section 7.8 on page 216)

Indicator Light (see Section 7.9 on page 216)

Numeric (see Section 7.8 on page 216)

Numeric/Precision (see Section 7.11 on page 220)

Rolling Road (see Section 7.11 on page 220)

Line Graph (see 7.13 on page 222)

SMS Status (see Section 7.14 on page 222)

Time (hh:mm) (see Section 7.15 on page 222)

Time (hh:mm:ss) (see Section 7.16 on page 223)

VDR Status (see Section 7.17 on page 223)

Weather Screen (see Section 7.14 on page 222)

Wind Rose (see Section 7.19 on page 226)

Moon Phase (see Section 7.20 on page 226)

SMS Signal Strength Bar (see Section 7.21 on page 226)

Trim Tabs Bar Graphs (see Section 7.21 on page 226)

Swing Meter (see Section 7.23 on page 227)

Tank Gauge (see Section 7.24 on page 228)

Watermaker Status (see Section 7.25 on page 228)

Switch/Breaker Display (see Section 7.25 on page 229)
5.2.6.4.2 Instance
Instance is used to specify which product on the network will be used as the source of the displayed
information. For example, there may be two GPS’s on the network each of which will have a unique
instance assuming the network has been properly configured. You use the instance field to tell the
DSM410 which GPS to use for displaying data. Most of the time, the DSM410 simply displays a
single
parameter from a device on the network so you will only see one “Instance” entry. There are
other parameters that the DSM410 displays that are a combination of information from multiple
products on the network. For example, fuel economy is a combination of fuel rate and Speed Over
Ground (SOG) so you will see two “Instance” entries, one to specify the engine(s) and one to specify
the GPS for SOG.
5.2.6.4.3 Alert
In setting up the Anchor Watch display type, this field is used to specify the associated Anchor Watch
Alert priority. The list from which the selection is made will be limited to the list of Anchor Watch Alerts
already created in the system.
5.2.6.4.4 Title
Each display type has a user defined title that is displayed above the control. The contents of the title
are specified in this field. There are three options: