- 3 -
indicator light on under the rubber cap. Once charging is complete, unplug
the charger, remove the USB charging cable from the system, and properly
seal the rubber cap. Best practice is to charge after every use regardless of
how far down the battery was discharged. This will ensure the longest
run-time each time the system hits the water.
OPERATION
The Control panel located on the front right side of system features four
buttons, with one on the left side.
Power Button
The bottom button powers the system on and off. Press the power button to
turn the system on. A start up screen with the MarCum logo will briefly show,
followed by the video image. To turn the system off press and hold the power
button for 5 seconds until the system shuts down. A quick press of the power
button will also act as a back button while in the menu screen.
LED/Up Arrow Button
The LED/Up arrow button serves a dual purpose. When selected it will turn
on and increase the intensity of the LED lights. An on-screen display will be
shown momentarily to indicate the light intensity level selected. There are
four intensity levels and an off selection. When in the menu section of the
system, this button serves as an up selection.
IR/Down Arrow Button
The IR/Down arrow button serves a dual purpose. When selected it will turn
on and increase the intensity of the Infrared lights. An on-screen display will
be shown momentarily to indicate the light intensity level selected. There are
four intensity levels and an off selection. When in the menu section of the
system, this button serves as a down selection.
Menu/Enter Button
The Menu/Enter button serves a dual purpose. Pressing once accesses the
Menu system. Once inside the menu system it functions as the enter button.
Record Button
The Record button on the left side of the screen serves a dual purpose to
both take a picture and record video. (see “Built-In DVR”)
PURSUIT HD MENU OPTIONS
For ease of use, the menu system on the Pursuit HD times out after a 5
second period of inactivity and defaults back to the camera image without
any additional keystrokes required.
Enter the Menu system with a single press of the top Menu/Enter button. Use
the Up or Down arrow buttons to navigate to the desired selection, followed
by the Enter button to enter and change that setting. Repeat this process
within the other menu sub-sections to make adjustments.
Monitor Setting
Brightness
- Controls the monitor backlight.
OSD
– Set the on-screen displays on or off.
Units
– Controls OSD displays in either standard or metric units.
www.MarCumtech.com
