Versa Electronics
www.marcumtech.com
3.
When the charger is plugged into both the wall
and
the battery, there should
be a red light showing on the charger. A red light showing indicates that the
charger is in contact with the battery and is actively charging the battery.
Once the battery has reached a voltage level that is considered “fully charged”
the red light should change to green. If after 24 hours the light has not
changed to green there is no cause for alarm! Remember that when the light
is red, the battery is being charged, and you will be able to use your system.
4.
If the charger is plugged into the wall and battery, and you get a blinking light on
the charger, it is very likely that the battery is faulty and should be replaced.
Battery Draw
The
VX-1i
has a current draw between 250 and 300mA per hour. With a
standard 7.2-amp hour battery, the
VX-1i
should last between 18 and 22
hours if fully charged. To extend the battery life, recharge the battery after
every use.
Cone Angle Coverage
The cone angle of all
VX-1i
transducers is 20 degrees. The approximate area of
coverage with a 20 degree transducer is determined by dividing the depth by 3
(in 30 feet of water your area of cover- age is approximately 10’).
Product Performance Specifications
Output Power . . . . . . . . . . . . . . . . . . . . . . 1000 watts peak to peak
Depth Ranges . . . . . . . . . . . . . . . . . . . . . . 20, 40, 80, & 160 feet
Transmit Frequency . . . . . . . . . . . . . . . . . . 200 KHz
Current Draw . . . . . . . . . . . . . . . . . . . . . . . 250 mA
Operating Voltage . . . . . . . . . . . . . . . . . . . 10.5 to 15 volts (12-volt DC)
Display Colors . . . . . . . . . . . . . . . . . . . . . . Red, Orange, Green
Transducer Cone Angle . . . . . . . . . . . . . . . 20 degrees (all transducers)
Target Separation . . . . . . . . . . . . . . . . . . . 2.15 inches (20-foot depth scale)
- 9 -
Summary of Contents for VX-1i
Page 1: ......
