LX Series Universal Open Water Dual Beam Transducer
User Guide
We recommend you purchase a “hose clamp” (enclosed circular clamp), to affix the transducer via the trolling motor
mount. Please measure the diameter of your trolling motor to purchase the appropriately sized clamp. Attach the clamp
by placing it in the groove of the transducer mount and then encircling the motor. Tighten the clamp so the transducer is
unable to slide and move. Please make sure the transducer is placed at the bottom of the trolling motor and facing
downward. If the transducer is at an angle it can cause improper sonar readings.
Wiring your Power Cable
The MarCum LX-Series Universal Open Water Dual Beam Transducer comes equipped with a power cable to attach your
unit to a battery. This power cable comes with two blank ends and no terminals, because of the wide variety of power
connections and lengths of power cable needed. You are able to attach more cable (if needed), and choose the terminals
needed to properly connect to your specific power source.
Mounting Sonar to the Boat
To mount your system you can attach the gimbal bracket to the boat at the location of your choosing. We recommend
somewhere where it will remain relatively dry, such as your console behind a windshield, if available. You can either use
the same gimbal bracket you have within your soft pack by removing it from the shuttle, or you could purchase another
gimbal bracket on our website,
www.marcumtech.com
and affix that bracket permanently.
Once set up all you need to do is connect your transducer to the unit, power on, and go fishing! We hope you enjoy your
sonar on the open water as much as you do on ice. Good luck fishing!
www.marcumtech.com
MarCum Technologies
3943 Quebec Ave North
Minneapolis, MN 55427
763-512-3987
International: 1-888-778-1208
