Reference numbers refer to the
sections below on how to fit these
parts.
If any damage beyond these parts
occurs please return the camera to
Marconi Applied Technologies or an
authorised repair centre. Any attempt
at repair by unauthorised personnel
may cause serious damage and will
invalidate the warranty.
1.5.4
Sidestraps (DAS532948AA)
These are retained by two screws on
each side. Once these screws are
undone the straps may be lifted off.
The replacement pair contains all new
parts required. The old strap and
screws can be discarded. Replacement
is the reverse of removal.
1.5.5
Heat Insulating Muff
(DAS532951BA)
This is supplied as one piece including
insulation and BNC cover. Also
included in the kit is the secondary lens
seal.
First remove the sidestraps as per
1.5.4. The muff can be spread at the
rear and pulled forward and upward
off the main camera.
If required the secondary lens seal can
now be replaced. This simply pulls off
the camera. To replace, align the tabs
with the slots in the main casing and
press home, moving progressively
round the lens.
Replacement of the heat insulating
muff is simply the reverse of removal.
Note:
Cameras fitted with
temperature measurement require a
different outer cover with holes for the
sensors (DAS548088AA).
1.5.6
Neckstrap (DAS532982AA)
This is removed simply by undoing the
karabiner attaching it to the camera. If
any part of the neckstrap is damaged
it should be replaced as a complete
assembly.
14
