38 - Installation manual - Eletta
®
•
Go into the internal space of the tipper body for setting up the chains (two n. 10 open-ended spanner are required);
•
Let the rear closing system manually come down (fig. 2);
•
Readjust the chain in order that it is perfectly tightened once the rear closure has come down (fig. 3).
fig. 3
4.1.1 Installation of reinforcing brackets for automatic rear closing in case of lowered cables
In case of installation of the "lower cable system", and
together
, of the automatic rear closing system,
it is absolutely
mandatory
to assemble an additional reinforcing bracket kit on both sides of the covering.
This system has to be positioned between the rear tensioner plate and the supports of the double pulling bow, and it is made
up of:
•
Reinforcing support plate and counterplate (with adjustable stroke) for the pulling double support;
•
Clamp, screws and self-locking nuts for fastening the plates.
For installing, proceed as follows:
FINAL RESULT OF THE OPERATION
1. Remove the screws and the self-locking nuts from the external bow support of the double pulling bow
(2)
.
2. Position and fasten the support plate
(1)
on the pulling bow support
(2)
, with the supplied screws
(3A
and
3B)
and self-
locking nuts
(11)
.
3. Put one supplied clamp
(6)
on the inner side of the support counterplate
(7)
and fasten it with the supplied self-locking
nuts
(8)
to end of the cable which comes back from the rear side of the vehicle.
4. Adjust the desired stroke and fasten the counterplate
(7)
on the support plate
(1)
with the supplied screws
(5)
and self-
locking nuts
(9)
, or alternatively, use only the support plate
(1)
.
5. Tighten properly the clamp
(6)
.
6. For greater safety, it is mandatory to fasten one additional clamp
(4)
on the right of the pulling bow support, with the
supplied nuts
(10)
.
