8516 Hybrid NVR with RAID Installation Guide
23
Feature Overview
Power Connector and Fuse Compartment
The power connector and fuse compartment are located on the back of the unit.
Power Connector
Connects the docking station to a power source via a connected power
cord.
For the unit’s power ratings, see “Specifications” on page 12.
For information on powering the unit, see “Turning the Unit On and Off” on
page 41.
Fuse Compartment
Contains one type “T” 5 millimeter x 20 millimeter glass fuse, rated for 2.5
A and 250 volts AC.
Replacing the Fuse
The fuse is located in the fuse compartment at the base of the AC power cord connector.
To replace the fuse, power down the unit, remove the AC power cord from the rear of the docking
station, and then remove the fuse compartment.
Replace the damaged fuse with a type “T” 5 millimeter x 20 millimeter glass fuse, rated for 2.5 A
and 250 volts AC.
WARNING:
Do not attempt to replace the fuse while the unit is powered or while the AC power
cord is attached to the docking station, as you may suffer serious personal injury.
Consult an electrician or a qualified service technician if you are unfamiliar with fuse
replacement. For information about powering down the unit, see “Turning the Unit
On and Off” on page 41.
Fuse Compartment
Power Connector
