Water Sensor Puck Setup
Step 1:
Log-in
and pair
the
SPuck to
the base
unit
Prior to setting up a water SPuck, make sure your
MarCELL PRO base unit is registered and operating
properly.
Registering a SPuck connects it to your account and a
specific MarCELL PRO base unit.
Go to
www.marcellpro.com
Click on login to access your account
Select “My Devices”, then select the base unit you want to link
your SPuck to.
Select “add SPuck” and follow instructions on screen.
Accept or change Temperature, Humidity safe ranges
After completing the SPuck registration online, the new SPuck will be
wirelessly paired with your MarCELL PRO unit. (this process may
take a few minutes and result in the base unit blinking its green
power light)
Step 2
Test and
select
location
To ensure that a SPuck can communicate properly with the MarCELL
unit, perform the following test by standing a few feet from the
MarCELL PRO unit.
- Flip SPuck over and press and release the test button. Note that
the blue LED will light for a second or two and then turn off.
- The SPuck will send a wireless signal to the MarCELL PRO base
unit. If the MarCELL PRO base successfully receives this message,
it will flash its green power LED indicator for 30 seconds. (you will
not however receive any alerts with this test)
Next, test again from the location the SPuck will be placed. Again,
note if the base unit blinks green after hitting the test button on the
SPuck. If it does not, refer to trouble shooting page.
Step 3
Place
into
service
Place the SPuck so that the metal “feet” are flat on the surface.
If water come in contact with any pair of the feet, the SPuck will
send a wireless signal to the MarCELL PRO base unit and
dispatch the alert you have set up.
IMPORTANT: Once a water SPuck detects the presence of
water and sends a signal, it automatically deactivates to
conserve its battery. In order to reactivate the SPuck, turn it
over and press the test button. Once the blue LED blinks – your
SPuck is back in service.
