14
Warning!
In the case of “split bypass” operation, make sure the copper between
each input lines have been removed. The AC input and the AC bypass
supplies must be referenced to the same neutral point.
Choose appropriate power cabling (refer to the table above
).
The diameter of the connection
terminal on the cables should be greater than or equal to that of the connection terminal blocks:
WARNING!
If the load equipment is not ready to receive power, ensure that the
system output cables are safely isolated at their ends. Connect the
safety ground and any necessary bonding ground cables to the
copper ground screw located on the base of the equipment below
the power connections. All sections of the UPS must be grounded
properly.
CAUTION!
The grounding and neutral bonding connections must be in
accordance with local and national electrical codes.
