Marantz SR7012, Owner'S Manual

Page: 253 / 370

o
HDMI Audio (ZONE2 only)
Selects the audio signal format for playing an HDMI source in ZONE2.
Through
(Default):
The HDMI audio signal is passed through
this unit to the device in ZONE2.
PCM:
The HDMI audio signal input into this unit
is converted to a PCM signal that can be
output from the ZONE2 PRE OUT
connectors or speaker terminals.
o
Volume Level
Set the volume output level.
Variable
(Default):
Volume can be adjusted.
1 – 98
(–79 dB – 18 dB):
Volume is fixed at the desired level. The
volume cannot be adjusting using the
remote control unit.
0
The dB value is displayed when the “Scale” setting is “ –79.5 dB – 18.0 dB”.
(
v
p. 185)
o
Volume Limit
Make a setting for maximum volume.
60 (-20 dB) / 70 (-10 dB) / 80 (0 dB)
(Default : 70 (-10 dB))
Off:
Do not set a maximum volume.
0
This can be set when “Volume Level” is set to “Variable”. (
v
p. 253)
0
The dB value is displayed when the “Scale” setting is “ –79.5 dB – 18.0 dB”.
( v p. 185)
o
Power On Volume
Define the volume setting that is active when the power is turned on.
Last
(Default):
Use the memorized setting from the last
session.
Mute: Always mute when power is turned on.
1 – 98
(–79 dB – 18 dB):
The volume is adjusted to the set level.
0
This can be set when “Volume Level” is set to “Variable”. (
v
p. 253)
0
The dB value is displayed when the “Scale” setting is “ –79.5 dB – 18.0 dB”.
( v p. 185)
Contents Connections Playback Settings Tips Appendix
253
Front panel Display Rear panel Remote Index