57
Fig 2. Input selection order by pressing [ MODE] button each time
ORDER
INDICATION for
FLD
INPUT STATUS
1
AUTO D1
DIG. 1 IN
2
AUTO D2
DIG. 2 IN
3
AUTO D3
DIG. 3 IN
4
AUTO D4
DIG. 4 IN
5
AUTO D5
7
AUTO CD
CD IN (Analog)
6
AUTO D6
DIG. 5 IN
DIG. 6 IN
Note: Surround mode is fixed “AUTO” mode automatically.
3.2. 5.1 channels output mode
This mode is available to output the same signal from 5 channels, even though 2 channels audio signal comes in.
As the result, all channels output can be confirmed by using analog stereo signal or PCM audio signal.
AC-3 or DTS source is not necessary to output from any channel in this mode.
1. When FLD shows "ALL CH D1" (Refer to "3. Input and output test mode"), the input can be shifted by pressing [ MODE ]
button for the remote commander only each time as shown in Fig 3.
( [ MODE ] button is in page4 of AMP function for RC-18SR*)
2. Supply to 2 channels PCM signal for digital input or 2 channels analog signal for analog input. But, Left channel and Right
channel of input signal should be equal.
3. Then each output from the product is the same as the input signal. (Subwoofer channel is respond to lower than 100Hz signal)
Fig 3. Input selection order by pressing [ MODE] button each time
ORDER
INDICATION for
FLD
INPUT STATUS
1
ALL CH D1
DIG. 1 IN
2
ALL CH D2
DIG. 2 IN
3
ALL CH D3
DIG. 3 IN
4
ALL CH D4
DIG. 4 IN
5
ALL CH D5
DIG. 5 IN
7
ALL CH CD
CD IN (Analog)
6
ALL CH D6
DIG. 6 IN
3.3. Cross Over circuit for SPK setup
This mode is available to confirm Cross Over circuit for SPK setup.
1. When FLD shows "ALL CH D1"(Refer to "3. Input and output test mode"), the Cross Over mode can be selected by
pressing [ see Fig4 ] button for the remote commander only each time as shown in Fig 4. ( [ see Fig4 ] button is in page3 of
AMP function for RC-18SR)
Fig 4. SPK set up mode
SPK setup
Button
for RC-18SR
INDICATION for
FLD
Front L/R
Center
Surr. L/R
Subwoofer
[ CH+ ]
ALL CH D1
Large
Large
Large
ON
[ LVL+ ]
CROSS 1
Large
Small
Small
OFF
[ LVL- ]
CROSS 2
Large
Small
Large
OFF
4. Transistor MUTE mode
In mute situation on the product, output signal is muted by Volume control IC and muting transistor.
But, this mode is available to work the muting transistor only by the following steps.
1. When the product is FACTORY mode ( Refer to "1. FACTORY mode"), press [ MUTE ] button for remote commander only.
2. FLD shows "TrMUTE ON", then muting transistor circuit is active only.
5. How to reset the product
When the product is POWER ON, press both [ CLEAR ] and [ DISPLAY OFF ] buttons simultaneously.
FLD shows "DEFAULT" for 3 seconds, then all memories are cleared.
Note
*
: The remote controller RC2000mkII is available instead of RC-18SR for [ MODE] button.
