36
Set up speakers
7
Set up “Channel Select”
Use
ui
to select “Channel Select”, and then press
ENTER
.
Subwoofer
Measure
Channel Select
Surround Back
Measure (2 sp)
[RETURN] Return
MultEQ
Preparation
Set the following items
if necessary.
Pre Assign
Channel Select
Audyssey Auto Setup
Auto Setup Start
[RETURN]
[ENTER] Enter
Cancel
8
Use
ui
to select a channel.
Surround
Back
Select the number of surround back speakers to be
used. In this case, go to step 9.
• “Surround Back” can be set when “Pre Assign” is
set to “NORMAL”.
Subwoofer
Select for no subwoofer to be used. In this case, go
to step 10.
9
Use
o
p
to set whether or not a surround back
channel is measured.
Measure
(2 sp)
Set for measuring two surround back speakers.
Measure
(1 sp)
Set for measuring a surround back speaker.
Skip
Set for no measuring of a surround back speaker.
10
Use
o
p
to set whether or not a subwoofer channel
is measured.
Measure
Set for measuring a subwoofer.
Skip
Set for no measuring of a subwoofer.
11
Press
RETURN
.
Proceed to
STEP 1
Preparation
step 6.
NOTE
After performing Audyssey® Auto Setup, do not change the speaker
connections or subwoofer volume. In event of a change, perform
Audyssey® Auto Setup again.
5
Use
o
p
to select the
configuration of the connected
speakers.
NORMAL
Set for connecting the surround back speakers to
the FL/SBL/HL and FR/SBR/HR connectors in PRE
OUT.
F.HEIGHT
Set for connecting the front height speakers to the
FL/SBL/HL and FR/SBR/HR connectors in PRE OUT.
FRONT
Set for connecting the front speakers to the FL/SBL/
HL and FR/SBR/HR connectors in PRE OUT.
6
Press
RETURN
to exit the “Pre Assign” setting.
Basic v
ersion
A
dv
anced v
ersion
Inf
or
mation
A
dv
anced v
ersion
