6
3. Locate the Lens Holder Assembly from the ship-
ping carton and orient it as shown in figure 7. Us-
ing the appropriate tool, loosen the two hex head
screws located either side of center on the Lock-
ing Ring. Remove the hex head screws, lift up on
the Lens holder and Locking Ring removing them
from the Post. Refer to figure 8.
Notes: Set aside the Lens, Lens Holder and Locking
Ring as they will be used after the VP-11 Pro-
jector/EXT10/MT20 have been installed and
initial setup adjustment have been made. The
actual Lens Holder Assembly is black in color.
The above illustrations are shown for purposes
of clarity.
4. Place the Lens Holder Base onto the Mount-
ing Plate 4 with the Lens Holder Post oriented
towards the outside edge of Plate 4. Secure the
Lens Holder Base with the four supplied 1/4-20x1
machine screws. Refer to figures 6 and 9.
5. Set aside the
just assembled
LN7101F/Plate
#4 for later use
and proceed to
the MT20 As-
sembly.
Assemble the LN7101F by performing the steps be-
low:
1. Locate Plate
#4 and the Top
Adjustment
Plate from the
LN7101F ship-
ping carton
and orient it as
shown. Refer to
figure 4 and 5.
Note: Plate #4
supplied
with the
MT20 Ceil-
ing Mount
Bracket Kit will
not be used.
2. Orient Plate 4 and
the Top Adjustment
Plate as illustrated in
figure 6. Secure the
two plates together
using four 1/4-20x1
socket head cap
screws, two at each
side and tighten
them with the sup-
plied Hex Wrench.
Set the Pole Pieces
to the desired length
and secure the posi-
tion using the two
Round Head Phil-
ips 1/4-20 x 2-1/4
Screws and two 1/4-
20 Lock Nuts. Refer
to figure 3.
5. Tighten all the re-
cently install hard-
ware and proceed
to assemble the
LN7101F.
14-5/8” to 24”
24” to 43-3/4”
Figure 3
EXT10 Assembly, con’t
LN7101F Assembly
Figure 9
Mounting screw
locations
Mounting
screw
location is
behind post
Plate #4
Top
Adjustment
Plate
Screws
1/4-20
tapped hole
Figure 6
Side View
Figure 5
Top Adjustment
Plate
Figure 4
Plate #4
Lens Holder Assembly
Figure 7
Loosen screws
Remove
screw
Base
Figure 8
Post
with
base
Lens
holder
Locking
Ring
Lens
alignment
collar
Alignment
collar
locking
screws
