THE ALARM
l) Press the u F" function key then theUr-G" lock key The red LED flashes and the beeps for the exit delay time that
you have set. Leave the protected area during this time and when the beeps finish the alarm is set.
2) To save battery power, the unit will enter "Conserve" mode automatically 60 seconds later.
TO DISARM THE ALARM (ALARM MODE ONLY)
To disarm the alarm, press the "F" function key then your 3 digit PIN and the alarm will be disarmed
HOW THE ALARM WORKS (ALARM MODE oNLY)
l) When detection is made, the red LED flashes, after the delay time, the alarm will sound unless the "F• ffnction
key and your PIN is entered. If these keys are not pressed, the alarm will sound for 30 (60) seconds then re-set
itself automatically
2) If f.rrther movement is detected during the reset period, the alarm will sound after, and without a delay.
3) While in alarming period, enter your PIN digit by digit checking the LED lights with each press to make sure each
key-in is correct
INTRUDER ALERT (ALARM MODE ONLY)
Once the unit has been triggered in the last ALARM period, the beep tone will sound instead of the I FD flashing
during entry delay time This indicates the alarm has been activated. This also means that the intruder has intruded
before. Clear the intrusion memory by entering your PIN.
IMPORTANT
1) Do not place the alarm close to ear as it could cause hearing damage.
2) When the batteries are removed and replaced again, the PIN (Penonal Identification Number) should be
re-set to 333 automatically. However the programmed code may still remain. If this is the case, remove
the batteries and press the "F" function key for 3 seconds then replace the batteries.
TOP VIEW
SIDE VIEW
2M——
1M
23456
7 8 9 10 (M)
MODEL NO. : KF 6
4
000
4
to