1010-1018 Rev 06 www.maplesystems.com
Introduction
Thank you for purchasing a Maple Systems HMI5000L Series graphic
industrial operator interface terminal. This booklet describes the steps
necessary for installing the HMI5043L, HMI5043LB, HMI5070L,
HMI5070LB, HMI5070NL, HMI5097XL, HMI5097NXL, HMI5100L,
HMI5121XL, and HMI5150XL models. The HMI5000L Series
touchscreens are configured using the EZwarePlus software (purchased
separately).
For information on programming and configuring the HMI, please refer to
the
EZwarePlus Programming Manual
(P/N 1010-1015) available on
the EZware software DVD.
For additional information, please refer to the Support Center
section of
the Maple Systems website, www.maplesystems.com. The Support
Center provides links to information such as Manuals, FAQs, Technical
Notes, Training Videos, Sample Projects, Controller Information Sheets,
and Controller Cables.
Static Awareness
Do NOT remove the rear cover of the HMI5000L Series product
– doing
so will void the warranty. When the rear cover is removed the circuitry
inside is exposed to possible damage by electrostatic discharge during
handling.
Minimize the possibility of any electrostatic discharge by:
Handling the HMI at a static-free, grounded workstation.
Discharging personal static by grounding yourself prior to
handling the HMI.
Connecting the chassis ground (FG or
⏚
) connector of the HMI
to a clean earth ground.
Placing the HMI in an antistatic bag during transport.
HMI5000L Series
Installation Guide
