Descaling
Descaling signal
: when warning light
D
blinks
YELLOW
and the machine beeps 3 times, a
descaling cycle should be carried out, as illustrated below.
The machine features an advanced program that monitors how much water is used
to dispense beverages. This measurement provides the user with indications as to
when the machine needs to be descaled.
It is advisable to use the Caffi taly System descaling agent. It is designed to comply with
the technical characteristics of the machine, in full observance of consumer safety. The
descaling agent must be disposed of in compliance with manufacturer instructions
and/or with current regulations in force in the country where the appliance is used.
CAREFULLY
read the directions for use on the packaging of the descaling agent.
Avoid contact with eyes, skin and machine surfaces.
Switch the machine off during descaling, and do not lift the lever. A person must be
present during the operation.
Do not use vinegar: it could damage your machine!
•
Switch the machine off by pressing the power on/off switch (Fig. 14).
•
Empty and rinse out the used capsule drawer and drip tray (Fig. 6).
•
Remove and empty the water tank (Fig. 5).
•
Mix the contents of a bottle of Caffitaly System descaling agent with approximately 1 litre
•
Place a container (at least 250 ml) under the dispensing spout (Fig. 9).
•
Make sure that the lever is lowered (Fig. 3) and there is not a capsule inside the capsule
compartment.
•
Press and hold buttons
A
and
B
while switching the machine on by pressing the power
on/off switch.
• Button
B
will light up, while warning light
D
blinks
YELLOW
and
RED
alternately.
• Press
button
B
to start the descaling cycle.
•
The machine dispenses the descaling solution at intervals (
5 doses with a 10-minute
pause between each one, for a total duration of about 45 minutes
). During this step,
when the buttons must not be pressed
, warning light
D
blinks
YELLOW
and
RED
alternately.
•
If the container fills up, empty it.
•
When the cycle is complete, as weel as the button
B
, the warning light
D
blinks
YELLOW
and
RED
alternately.
•
Carefully rinse out the water tank and refi ll it with fresh water (Fig. 4).
•
Empty and rinse the used capsule drawer, the drip tray and the container used and put
them back in place (Fig. 15).
• Press
button
B
to start the rinse cycle.
•
Rinse water will be run through the machine. During this step, warning light
D
blinks
alternately (twice
YELLOW
and twice
RED
).
•
When the rinse cycle is complete, in addition to the button
B
, the warning light
D
blinks
YELLOW
and
RED
alternately.
•
Carefully empty and rinse out the water tank and fill it wish fresh, still water (Fig.4) .
•
Empty and rinse out the used capsule drawer and drip tray (Fig.6).
•
Press the button
B
to quit the cycle.
11
of water and pour into the tank.
