4
A. Safety Decals
An important part of the safety system incorporated in this
trimmer are the warning and information decals found on
various parts of the trimmer. These decals must be replaced in
time due to abrasion, etc. It is your responsibility to replace the
decals when they become hard to read. The location of these
decals and their part numbers for ordering are shown below.
B. General Safety Rules
1. THIS MACHINE CAN CAUSE SERIOUS INJURIES. Read
the instructions carefully for the correct handling, preparation,
maintenance, starting and stopping of the machine. Be familiar
with all controls and the proper use of the machine. Pay
particular attention to all sections regarding safety.
2. Always keep a firm grip on both handles while the blades
are moving and/or the engine is running. On single edge units
the right hand grasps the front side handle and the left hand
grasps the rear handle. BE AWARE!! The blades coast after
throttle trigger is released or engine is switched off. Make sure
blades have come to a complete stop and engine is off before
releasing a handle.
3. Maintain a firm footing and good balance, do not overreach
while trimming. Before you start to trim, check the work area
for obstacles that might cause you to lose your footing, balance
or control of the machine. While operating the machine always
be sure of a safe and secure operating position especially when
using steps or a ladder.
4. Keep area clear of children, pets, and bystanders.
5. Blades coast after throttle trigger is released or engine is
switched off.
6. Stop the engine before checking, maintenance or working
on the machine.
7. Never operate without guards, handles and safety devices
in place.
8. Never attempt to use an incomplete machine or one fitted
with an unauthorized modification.
9. To reduce fire hazard, keep engine and silencer free of
debris, leaves, or excessive lubricant.
10. Know how to stop the machine quickly in an emergency.
WARNING!
WEAR EYE AND EAR
PROTECTION
READ AND UNDERSTAND
OWNER’S MANUAL BEFORE
USING! KEEP IN SAFE PLACE!
CUTTING HAZARD! KEEP BOTH
HANDS ON HANDLES AND AWAY
FROM BLADES!
EAR/ EYE
PROTECTION
LABEL P/N 4036
MANTIS
LABEL P/N 357M
MUFFLER
LOCKOUT
TRIGGER
STOP
SWITCH
THROTTLE
TRIGGER
REAR
HANDLE
FUEL TANK CAP
GEAR HOUSING
WARNING LABEL P/N 300605
MODEL NO. LABEL
FRONT SIDE HANDLE
ADJUSTING
SCREW AND
BLADE GUARD
FRAME
BAR
STARTER HANDLE
SPARK PLUG WIRE
THROTTLE CABLE
PRIMER BULB
AIR CLEANER
CHOKE KNOB
CUTTING
BLADES
Safety and Warnings
An Emission
Control Label
is
located on the engine
(This is an EXAMPLE
ONLY, information on
label varies by
engine FAMILY.)
EMISSION CONTROL
The emission control system for the engine is EM/TWC (Engine
Modification and 3-way Catalyst) and for the fuel tank the Control
System is EVAP (Evaporative Emissions) or N (for nylon tank).
Evaporative emission may be applicable to California models only.
WARNING - DANGER
IMPROPER USE OR CARE OF THIS TRIMMER, OR
FAILURE TO WEAR PROPER PROTECTION CAN
RESULT IN SERIOUS INJURY.
READ AND UNDERSTAND THE RULES FOR
SAFE OPERATION AND ALL INSTRUCTIONS IN
THIS MANUAL.
WEAR HEARING PROTECTION.
WARNING - DANGER
IF TRIMMER IS USED IMPROPERLY OR SAFETY
PRECAUTIONS ARE NOT FOLLOWED. THE USER
RISKS SERIOUS INJURY TO THEMSELVES AND
OTHERS.
READ AND UNDERSTAND THE FOLLOWING
BEFORE ATTEMPTING
TO OPERATE THIS HEDGE TRIMMER
320709 Gas Hedge Trim EN_320707 Gas Hedge Tri#1D84A8.qxd 7/29/10 11:23 AM Page 4
