5
Electric Tiller
A s s e m b l y
WARNING DANGER
IMPROPER ASSEMBLY OF THIS TILLER CAN RESULT IN SERIOUS INJURY.
MAKE SURE TO FOLLOW ALL INSTRUCTIONS CAREFULLY.
IF YOU HAVE ANY QUESTIONS CONTACT OUR FACTORY AT
1-800-366-6268 OR AN AUTHORIZED DEALER.
Your MANTIS Electric Tiller comes partially
assembled. You must install only the handlebars, the
handle brace, and the tines. This will take just a few
minutes if you follow the directions.
First, take all items out of the carton. But do not
remove the cardboard from around the tiller’s base.
The list below, shows the parts that come with your
tiller. Check to make sure you have them.
The bag of hardware is in the plastic bag containing
the Owner’s Manual and Video.
To assemble your MANTIS Electric Tiller, you’ll
need two 7/16" wrenches. We suggest that you install
all nuts and bolts only “finger tight” — that is, one-
half to one full turn — until you’ve completed
assembly. The nuts are self locking, but you must
use a wrench to tighten them completely.
Qty. Description
*Key #
1
Upper Handle Assembly
7
1
Upper Handle Trigger Assembly
1
2
Lower Handles
10
1
Pair Tiller/Cultivator Tines
54/55
1
Motor Assembly (includes Fender
Guard, WormGear Transmission
& Complete Housing)
62**
1
Handle Brace
14
1
Bag of Hardware Containing:
2
Round Head Square Neck Bolts
16
4
Lock Nuts
17
2
Bolts (3" long)
20
2
Tine Retaining Pins
53
2
Handle Clamps
19
2
Bolts (1" long)
13
2
Knobs
12
2
Cable Clamp
18
*These numbers are the same numbers shown on the Parts Layout on
pages 16 and 17.
**This Key # is for assembly purposes only.
12
20
13
16
18
53
17
19
62
54, 55
14
1
7
10
A.
Parts
