The Vertical Braces {27} are always mounted higher than
the bottom of the TV. However, the Brace Extenders {28}
will be mounted one of two ways:
Without a Sound Bar, if needed
- The Brace Extenders
are installed slightly
above
the bottom of the TV. Use the
Extenders for holes that are low on the TV.
With a Sound Bar
- The Brace Extenders are installed
below
the TV with enough room to install the Sound Bar
onto the Horizontal Brace {29}.
Attach the Vertical Braces {27} to the TV so the bottoms of
the Vertical Braces are at least seven inches higher than the
bottom of the TV (so that the TV covers the Recess Frame).
NOTE: If all the screws for the back of the TV can fit into the
TV Vertical Braces {27}, and a soundbar is not being used,
then the Brace Extenders {28} do not need to be installed.
Attach the TV Horizontal Brace {29} with Screws {18}.
Use the Vertical Braces to align the Extenders for
tightening if the TV is going to block access to the screws.
Then attach the Extenders to the Vertical Braces using
Screws {19} and Nuts {16}.
Measure the distance from the bottom of the Vertical
Braces {27} (not the Extenders) to the bottom of
television or Sound Bar.
Write down this distance to use in Step 9.
Use this distance in Step 9
Without
Sound Bar:
Extenders are
only needed for
TV holes that
are close to the
bottom of the TV
Vertical Braces:
Always higher
than the bottom
of the TV
With
Sound Bar:
Extenders are
a few inches
below the TV
7 to 10
INCHES
{16}
{19}
{28}
{27}
Bottom of
Vertical Brace
Bottom of
Vertical Brace
Bottom of TV
Bottom of
Sound Bar
{18}
{29}
MantelMount MM8
PAGE 5
5
5
5
6
5
7
5
8
