ASSEMBLY TEMPLATE
NOTE:
1.
ALL WATER, ELECTRICAL, AND GAS CONNECTIONS SHOULD BE
PERFORMED BY A TRAINED PROFESSIONAL PER LOCAL CODE.
REVISION LEVEL
EMK
10/26/16
CREATED DRAWING
REV.
A
-
DWN
BY:
BY:
APR
DATE:
DWN
APR:
DATE
REVISION:
SCALE:
SHEET:
DRAWING NUMBER:
THIS DRAWING IS THE SOLE PROPERTY OF
DIVERSIFIED WOOD CRAFTS. IT MAY NOT
BE ALTERED OR CHANGED WITHOUT
PERMISSION
BY:
APR
APR:
DATE
STUDENT SERVICE ISLAND
STUDENT SERVICE ISLAND-SINGLE
ASSEMBLY INSTRUCTIONS
REV A
5 OF 6
NTS
EMK
10/26/16
NAME
DATE
DESCRIPTION
ECN NO.
UNLESS OTHERWISE SPECIFIED
DIMENSION ARE IN INCHES
STEP 8:
IF YOU DO NOT HAVE A "K" SERIES UNIT, SKIP TO STEP 9. APPLY SILICONE
ADHESIVE TO THE SINK OPENING ON TOP. LOWER SINK INTO OPENING.
WIPE OFF ANY EXCESS CAULK AND ALLOW TO SET. LET CURE FOR 6-12
HOURS.
APPLY SILICONE ADHESIVE
HERE FOR SINK
TOP VIEW OF TABLE SHOWN
COMPLETE UNIT SHOWN
APPLY RUBBER
MOLDING HERE
STEP 9:
ATTACH RUBBER MOLDING TO BASE OF CABINET USING CONTACT CEMENT.
AFTER MOLDING IS IN PLACE, SCREW STAINLESS STEEL CORNER BRACKETS
ON EACH CORNER OVER BASE MOLDING WITH THE SCREWS PROVIDED. IF
YOU HAVE A "K" SERIES UNIT, INSTALL MULTI-SERVICE FIXTURES IN THE HOLES
PROVIDED ON TOP. INSERT ROD SOCKETS INTO PRE-DRILLED HOLES IN TOP.
TOP
MULTI-SERVICE
FIXTURES
ROD SOCKETS - TYPICAL
& C2710KF SERIES.dwg, 12/2/2016 12:00:41 PM, DWG To PDF.pc3
