GB - 9
Troubleshooting
A staple or nail may jam in the magazine when stapling onto hard surfaces. If this happens, stop work and do not
attempt to drive in any more staples or nails.
•
Before any work on the machine itself, pull the mains plug.
•
Press release buttons (7) and pull out the magazine (5) toward the rear.
•
Remove the jammed staple. For this, use a pair of pliers, if required.
•
Insert the magazine (5) again until the magazine lock (7) engages.
Load the magazine in good time. If the staple strip is too short, this may cause staples to jam
Care and servicing
The tool is virtually maintenance-free.
•
Occasionally clean the housing with a dry cloth.
•
Keep the hand grip and trigger dry and free of oil and grease.
•
Do not use solvents, as they might damage the housing.
•
Only have repairs carried out by an authorised repair workshop using original parts.
Full two-year guarantee
The guarantee period for your wall chasing machine begins on the day of purchase. Please supply proof of the
day of purchase by sending in the original receipt.
The guaranteed period covers the following:
•
Free removal of any faults.
•
Free replacement of defective parts.
•
Including free expert service (free assembly by our experts)
This guarantee is conditional upon the fault not being the result of improper handling.
If you have any queries or problems concerning quality, please contact the manufacturer:
Brüder Mannesmann Werkzeuge GmbH
Abt. Reparatur-Service
Lempstr. 24
42859 Remscheid, Germany
Tel.:
+49 (2191) 37 14 71
Fax:
+49 (2191) 38 64 77
Email:
