GROVE
2-25
TMS800E13 OPERATOR MANUAL
SAFETY INFORMATION
2
Published 02-06-2014, Control # 495-00
MODEL SPECIFIC INFORMATION
Access Platform Hand Rail
To gain access to the hoists deploy the hoist access platform.
Remove pins from hand rails (1) (Figure 2-1) and rotate up
into the working position, reinstall pins.
Before Traveling ensure that the hoist access platform hand
rails (1) (Figure 2-2) are in the travel configuration.
Remove pins from hand rails and rotate down into the travel
position, reinstall pins.
OVERLOAD INSPECTION
This information supplements the Rated Capacity Limiter
(RCL) manual supplied with each Grove crane.
When the RCL system has acknowledged an overload
on your crane, you must carry out specified inspections
on the crane.
These inspections apply only to overloads up to 50%. For
overloads of 50% or higher, crane operation must be
stopped immediately and Crane Care must be contacted
for corrective action.
NOTE: If your crane is equipped with CraneSTAR, an
overload warning will be posted to the web site
for review by the crane owner.
Overload warnings do NOT indicate real time
events! Warnings could be sent 24 hours (or
more) after the actual event.
DANGER
Falling Hazard!
Position superstructure to allow access to hoist platform
from decking.
Do not go beyond hoist access platform railing, death or
serious injury could occur.
FIGURE 2-1
1
Working Configuration
1
WARNING
Overload Hazard!
To avoid an accident caused by overload damage to
your crane:
•
Perform the inspections outlined in this publication
for overloads up to 50%.
•
Stop operating the crane and contact Manitowoc
Crane Care immediately for overloads of 50% and
higher.
FIGURE 2-2
1
1
Travel Configuration
Reference Only
