16
Part Number: 000015202 Rev 00 12/17
Maintenance
Section 4
PREVENTATIVE MAINTENANCE CLEANING PROCEDURE
Ice machine cleaner is used to remove lime scale or other mineral deposits. It is not used to remove algae or slime. Refer to
“Sanitizing Procedure” for removal of algae and slime. To initiate a cleaning cycle using Manitowoc’s Cleaning Technology use
the following procedure.
Step 1
To start a cleaning cycle, move the toggle switch to
the CLEAN position. Water will flow through the water dump
valve and down the drain.
Step 2
Remove the top panel and translucent plastic ice
chute cover. Wait about one minute then add the proper
amount of Manitowoc Ice Machine Cleaner. Rinse the cleaner
from the top of the evaporator with 2 ounces (60 ml) of clear
water and re-install cover.
Model
Amount of Cleaner
CNF201 CNF202
2 ounce (60 ml)
,
Caution
Use only Manitowoc approved Ice Machine Cleaner. It is a
violation of Federal law to use these solutions in a manner
inconsistent with their labeling. Read and understand all
labels printed on bottles before use.
ICE
WATER
ICE /
WATER
Add Cleaner To Evaporator Here
Step 3
The ice machine will run a wash cycle, a series
of rinse cycles and then stop. This entire cycle lasts
approximately 30 minutes.
NOTE: Periodic cleaning must be performed on adjacent
surface areas not contacted by the water distribution system.
NOTE: The ice machine may be set to start and finish a
cleaning procedure, and then automatically start ice making
again.
A. After cleaner is added, move the switch from CLEAN
to ICE position.
B. When the cleaning cycle is complete, ice making will
start automatically.
Changing toggle switch position during clean cycle:
1. Less than 60 seconds into Clean cycle - The Clean cycle
will end when the toggle switch is moved to the OFF
position.
2. More than 60 seconds into Clean cycle - The ice machine
will complete the Clean cycle. Toggle switch position
will determine the next cycle after the Clean cycle is
completed.
• CLEAN POSITION - The ice machine will wait for a change
in toggle switch position.
• OFF POSITION - The ice machine will wait for a change in
toggle switch position.
• ICE POSITION - The ice machine will start making ice
automatically.
Manitowoc recommends disassembling, cleaning and
sanitizing the ice machine and dispenser every six months.