PRINTED IN U.S.A.
63
50960025/CP0514
4.
Firmly grasp the retaining ring (A) and rotate it
clockwise 1/4 turn (when viewed from the top).
Remove the ring with filter element (B or E).
NOTE:
Lifting up on retaining ring (A) as it is rotat-
ed helps to get it past raised locators.
5.
Inspect filter mounting base for cleanliness. Clean
as required.
NOTE:
Raised locators on the fuel filter canister
must be indexed properly with slots in mounting
base for correct installation.
6.
Install new filter elements onto mounting bases.
Be sure elements are properly indexed and firmly
seated on bases. It may be necessary to rotate fil-
ters for correct alignment.
Remove filter element from seperator bowl (D).
Drain and clean the separator bowl. Dry with
compressed air. Install bowl onto new element.
Tighten securely.
7.
Align keys on filter element with slots in filter
base.
8.
Install retaining ring onto mounting base making
certain dust seal is in place on filter base. Hand-
tighten ring counter-clockwise (about 1/3 turn)
until it snap into the detent. DO NOT overtighten
retaining ring.
NOTE:
The proper installation is indicated when a
“click” is heard and a release of the retaining ring
is felt.
9.
Reconnect water sensor wiring on the filter (E).
After fuel filter replacement, bleed the air out of the
fuel system by following the fuel bleeding procedure
below.
Fuel Bleeding Procedure
When the fuel filter is removed and replaced, or if the
engine runs out of fuel, air must be bled from the sys-
tem. Refer to the following procedure for proper bleed-
ing procedure.
1. To bleed the fuel system, turn the ignition key to
the “ON” position for 60 seconds.
2. Start engine and check for leaks.
If the engine will not start, repeat step 1.
Diesel Fuel Injectors
Whenever faulty or plugged injectors are indicated, see
your authorized engine dealer.
Diesel Injection Pump Timing
Whenever injection pump timing, or other pump ser-
vice is indicated by abnormal engine operation, contact
your authorized engine dealer.
NOTE:
Only an authorized engine dealer can per-
form warranty service on the engine.
CHANGING ENGINE OIL AND FILTER
Change the engine oil and filter using the following
procedure:
1.
With the engine warm, remove the crankcase
drain plug.
IMPORTANT:
DO NOT discharge oil onto ground.
Catch and dispose of per local waste disposal
regulations.
2.
The engine oil filter should be changed at every
oil change interval. Using a suitable filter wrench,
remove and discard the filter.
WARNING
Escaping diesel fuel under pressure can have
sufficient force to penetrate the skin. Before
applying pressure to the fuel system, BE
SURE all connections are tight and lines and
hoses are not damaged. Use a piece of wood
or cardboard to search for suspected leaks. If
injured by escaping fuel, see a doctor familiar
with this type of injury at once or gangrene
may result.
B
C
A
E
A
D
