Manitou MT 1135 ST3B, Instruction Manual

Page: 135 / 159

3 - 32
F7 – AIR CONDITIONING (OPTION)
CLEANING - INSPECTION
CLEANING CONDENSER AND EVAPORATOR COILS (*)
CLEANING CONDENSATE TRAY AND RELIEF VALVE (*)
COLLECTING COOLANT TO REPLACE FILTER-DRIER (*)
REFILLING WITH COOLANT AND CHECKING THE THERMOSTATIC CONTROL AND PRESSURE SWITCHES (*)
NOTE: When opening the evaporator unit, remember to replace the cover seal.
(*): (CONSULT YOUR DEALER).
IMPORTANT
DO NOT ATTEMPT TO REPAIR ANY PROBLEMS YOURSELF. ALWAYS REFER TO YOUR DEALER WHEN REFILLING CIRCUITS, AS THEY HOLD THE CORRECT SPARE PARTS,
AS WELL AS HAVING THE NECESSARY TECHNICAL KNOWLEDGE AND TOOLS.
In the event of inhalation, take the victim into fresh air, give oxygen or artificial respiration if necessary and call a doctor.
In the event of contact with the skin, wash it immediately under running water and remove any contaminated garments.
In the event of contact with the eyes, rinse with clear water for 15 minutes and call a doctor.
- Do not open the circuit under any circumstances as this would loss of coolant.
- The cooling circuit contains a gas which can be dangerous under certain conditions. This gas, coolant R-134a, is colourless,
odourless and heavier than air.
- The compressor has a fluid level gauge; never unscrew this gauge because it would
depressurize the system. The fluid level should only be checked when draining the
system.
647104
(13/06/2016)
MT
835
/ 1135
/ 1335
ST3B