Manikin Electronic Schrittmacher, User Manual

Page: 18 / 36

The Gate and Len line parameters influence the note output as follows: Gate sets the interval
between two note-on events; Len defines the interval between a note-on and the respective note-off
event.
Figure 1 – Effect of Gate and Len on the note output
Midi
The Midi line parameter defines the MIDI output and the MIDI channel for a Note or Ctrl line. You can
set values from A01 to B16 with the letter indicating the MIDI output and the number the MIDI channel.
The Midi line parameter can be linked with and controlled by a Midi line.
Vel
The velocity of a Note line can be set by the Vel line parameter within the range from
0 to 127. At a velocity of 0 no note event is generated because it is usually interpreted by sound
generators as note off.
The Vel line parameter can be linked with and controlled by a Vel line, Key or Ctrl1-8.
Add
Using Add an additional offset is added to the steps of the Note , Ctrl and Vel lines. Note lines can be
transposed and Ctrl and Vel lines can be varied in their course. Add can only be linked with an Add
line or a controller. A constant value cannot be set. To do so use the Add editing aid described on
page 17.
The Add line parameter can be linked with and controlled by an Add line, Key or Ctrl1-8.
ID
The ID line parameters can only be found with Ctrl lines. Using ID you can select the controller to be
sent. The following settings are possible:
Pitch the Ctrl line sends pitch bend events
Ch.Aft. the Ctrl line sends channel aftertouch events
0 ... 120 the Ctrl line sends control changes with the set controller ID
The ID line parameter cannot be linked with and controlled by any other lines.
!
If you edit the ID line parameter while playing the preset, it is possible that
some settings of the connected sound generator are changed unintentionally.
Therefore always edit
ID in the stopped state.
Schrittmacher - Manual 16