9
TP All --
Selected TP for all Video and Radio channels. To select move to TP Data and press OK for
sub menu.
TP All + D --
Selected TP for all Video, Radio and Data channels.
TP FTA --
Selected TP for Free to Air Video and Radio channels.
Manual All –
Single TP for all Video and Radio channels. To select go to TP Data and press OK for
sub menu.
Manual All + D –
Single or user defined TP for all Video, Radio and Data channels.
Manual FTA –
Single or user defined TP for Free To Air Video and Radio channels
If you have added a TP, this will appear at the end of the list. Repeat above steps for all the satellites you wish
to search
NOTE: SIGNAL AND QUALITY (Channel Search Menu)
In channel search, the signal and quality conditions shown are as below.
Blue: Indicates noise only with no actual signal
Green: Indicates actual signal
Positioner:
Move down to Positioner and select
DiSEqC USALS
or
DC Auto
Now go to START and press OK key. The antenna will move to the first satellite in the index and
Searching
will start. After completing channel search, it will automatically scan and search the next satellite in the index.
This process is repeated until all satellites in the index are searched.
CHANNEL SEARCH: Manual Scan and Search
Configure Channel Search as described earlier then go to
Positioner
and select
DiSEqC 1.2
or
DC Manual.
Move the antenna until you find the correct position, maximum signal and quality and
store the position
START:
Press OK to start search.
Using a mechanical polarizer for your lnb
Connect the appropriate leads as shown on the output terminals (
R12
) at the back of the receiver. In
INSTALL
menu,
go to
Antenna Settings
and configure LNB as described earlier then configure the following.
TUNING WIDEBAND LNB
Select a satellite.
Set Multisat Search 1, LNB No 1 and select vertical TP from low band. Adjust skew to + value for maximum
signal and quality.
Set Multisat Search 2, LNB No 2 and select horizontal TP from low band. Adjust skew to - value for maximum
signal and quality.
Set Multisat Search 3, LNB No 3 and select vertical TP from high band. Adjust skew to + value for maximum
signal and quality.
Set Multisat Search 4, LNB No 4 and select horizontal TP from high band. Adjust skew to - value for maximum
signal and quality.
Finally press OK key on Start.
To select press VOL up / down. To edit or add, follow below settings.
To add select User Defined.
Freq:
Enter using 0-9 keys.
Polarity:
Select polarity
S / R:
Enter using 0-9 keys
FEC:
Select FEC
Video PID / Audio PID / PCR PID
Enter the channel PID using 0-9 keys
STORE: After above settings move to store and press OK key.
When searching, this page will show the TV and Radio channels found.
After completing the index, the positioner will move the antenna to the first
satellite.
USING A MECHANICAL POLARIZER FOR YOUR LNB
