mangOH Green DV4, Developer'S Manual, Page: 17 / 34

Hardware
Rev 2 Jun.16 17 4118903
Primary CF3 Module Signals
This section describes how the primary CF3 module‘s signals connect to the platform hardware
described in
mangOH Green Hardware Components on page 10.
Important:
CF3 module signal availability depends on the type of module used—some modules may not
implement certain Extension signals from the CF3 specification.
ADC
mangOH Green provides three ADC (Analog to Digital converter) signal sources (ADC0, ADC1,
ADC2) defined by the CF3 specification.
Note: The CF3 specification includes ADC3, which is not supported by the mangOH Green.
The primary CF3 module’s ADC signals connect directly to the mangOH Green IoT Connectors
(pin 20), as shown in
Figure 2-5 on page 17:
• ADC0—IoT Connector 0 (CN1000, slot IOT0)
• ADC1—IoT Connector 1 (CN1001, slot IOT1)
• ADC2—IoT Connector 2 (CN1002, slot IOT2)
Figure 2-5: ADC Configuration
Main CF3
ADC0
ADC2
ADC1
IoT Connector #0
(CN1000, slot IOT0)
ADC0
IoT Connector #1
(CN1001, slot IOT1)
ADC0
IoT Connector #2
(CN1002, slot IOT2)
ADC0