- 3 -
The first time you connect the remote to your PC, the operating system will notify you that a new device has
been found: the PC should proceed to find and install the remote control’s drivers automatically, without
requiring specific actions on your part. Wait until the PC has identified the device correctly and confirmed that
it is ready for use.
3.
run the Manfrotto Firmware Update GUI software on the PC
4.
click the “…” button (highlighted in red below) to navigate to the update file (*.upg) you saved on your PC.
5.
click the “Update” button to start the procedure (this button is enabled only after the *.upg update file has
been loaded, and only if a compatible remote control unit is properly connected to the PC)
6.
disconnect the remote control from the PC, then turn it off.
Please note:
After performing firmware updates, it is advisable to check proper functioning of the remote. In the event of
any malfunction or irregularity, try repeating the update procedure.
When the update file has been successfully applied and the
procedure has finished, a confirmation dialog box will appear.
