Swoon Pod
ASSEMBLY INSTRUCTIONS
ASSEMBLY WARNINGS:
•
Due to the presence of small parts during
assembly, keep components out of reach
of children until assembly is complete.
•
To prevent serious injury, children
must not use Cozy Hanging Pod until
properly assembled and installed.
BEFORE YOU BEGIN ASSEMBLY:
•
Assembly should be completed
by adult person.
•
Place the equipment on level ground.
•
Do not install Cozy Hanging Pod
concrete, asphalt or any hard surface.
•
A fall onto a hard surface can
result in serious injury or death to the equipment user.
•
No need to show gorilla strength while tightening bolts.
Over-tightening bolts or nuts can cause the threads
to get damaged making it difficult to take your Cozy
Hanging Pod apart or reassemble it in the future.
(Steps 1-5) Build Stand:
1.
Place
A (Circular Base)
on a level surface with the
non-skid feet resting on the floor surface.
2.
Connect
B (Vertical Height Pole)
to
A (Circular Base)
using one
E
(Round Hex Nut & Bolt)
and two
F (Washers).
Tighten hardware.
3.
Insert
C (Curved Top Section)
of stand to
B (Vertical
Height Pole)
using the remaining
E (Round Hex Nut &
Bolt)
and two
F (Washers).
Tighten hardware.
4.
Drop
D (Hanging Pin)
through the end of
C (Curved Top
Section).
The cap of the pin should be on top.
5.
Insert one end of
H (Spring)
through the hole
punched in the lower end of
D (Hanging Pin)
.
(Steps 6-7) Connect Stand and Swoon Pod:
6.
Slide the circular hanger at the top of the pod frame to the open
end of the
H (Spring)
. Make sure Pod opening for entering/
exiting seating is facing outward away from the stand.
7.
Place
J (Cushion)
in Cozy Hanging Pod.
(Steps 8-9) Attach Motion Resistant Bungee Strap:
8.
Connect one Carabiner on
K (Bungee Cord)
to the
horizontal rib running around the frame of the Pod.
9.
Bring
K (Bungee Cord)
around
B (Vertical Height Pole)
and return the
other end to the same horizontal rib of Pod to secure other Carabiner.
Confirm both Carabiners on
K (Bungee Cord)
are closed.
MM00147 INSTRUCTION MANUAL
ASSEMBLY • OPERATION • MAINTENANCE • SAFETY
What’s in the Box:
Lay out all box components included on
a level and comfortable workspace:
(1)—A Circular Base
(1)—B Vertical Height Pole
(1)—C Curved Top Pole with Cap
(1)—D Hanging Pin
15mm x 80mm
(2)—E Round Hex Nut & Bolt
M8 x 42mm
(4)—F Lock Washers
M8
(1)—H Spring
(1)—I Pod
(1)—J Cushion
(1)—K Bungee Cord w/ 2 Carabiners
(2)—L Hex Wrench
M8
Ages
3
+
Build Stand
(Steps 1-5)
Connect Stand
and Swoon Pod
(Steps 6-7)
Attach Motion
Resistant Bungee
Strap (Steps 8-9)
(A)
(B)
(C)
(D)
(E)*
(F)*
(H)
(I)
(L)
(K)
(J)
M&M Sales Enterprises, Inc.
1300 Synergy Court, Dubuque, IA 52002
877-242-0514 www.mandmsalesinc.com
125
LBS.
